Welding fume purifier

Welding fume purifier

The smoke generated by the welding is sucked by the suction arm of the suction fan through the gravitational action of the double air blower fan. Safety of flame retardant plate is arranged in the air inlet pressure equipment, the safety board is pressurized spark flame retention, smoke into the clean room, using gravity and air flow, first coarse dust directly to the dust collecting box, dust particles coated by PTFE cartridge collected on the outer surface of the dust in the filter is blocked the surface deposited continuously, to a certain extent, through the manual pulse cleaning cartridge, or by automatic pulse blowing clean dust on the cartridge, the cartridge dust particles deposited on the surface of the compressed air under the impact from the surface of the filter cylinder falls into a dust storage box. The cleaning gas is filtered and purified by PTFE coated filter tube, and then the PTFE film covered filter tube center flows into the double outlet fan, which is discharged through the efficient double outlet to achieve the effect of smoke cleaning.

Compact structure, small footprint. Double air turbine is adopted, the purification effect is good, and the filtration efficiency is high. Equipped with casters, you can move freely to meet the demand for flexible welding. The suction arm moves flexibly, rotates at 360 degrees, hovers arbitrarily, solves pollution problems from the source, and prevents contaminants from spreading indoors. Drawer type ash box design for daily maintenance. The use of high-quality energy-saving motors, efficient energy-saving environmental protection. The automatic electronic pulse reverse blowing system can be cleaned in all directions without leaving dead corners, improving the efficiency of purifier filtration, enhancing the purification effect and prolonging the service life of the cartridge.